1990 Chevrolet Blazer Tail Light Assembly CAPA Halogen

FAQ

Yes we do. Check out our PERDE Xenon and Krypton bulbs while looking up your vehicle. These cast a brighter, white light that reflects well off the road and allows you to see further in the dark. In most cases, these only use 35 to 65 watts. Here at headlightsdepot.com, we offer a limited Lifetime Warranty on perde bulbs. That's how much we believe in this product!

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

Your headlights will be warm to the touch from the heat generated by the bulb. The filament inside of a headlight bulb can reach temperatures of over 4000º F while the temperature of the glass surface of the bulb can exceed 150º F. This means that heat will naturally radiate to the exterior surface of your headlights. This intense heat is also what will help your headlights remain condensation and moisture free. However, to prevent burns or other injuries, be sure to let bulbs and headlight assemblies cool completely after use before handling.

Halo lights are lights arranged in a ring around the headlights themselves. You've probably seen them on some cars, such as BMWs, where they are the factory option. In some cases the effect is achieved with bulbs, while on other vehicles it's done with fiber optics. Halo Lights can be a popular upgrade to make your car or truck stand out at night. Please be aware that most of theHalo lights we sell typically have to be manually wired up to your existing wiring harness. This is because your stock vehicle did not have Halos, and there is no wiring pigtail for them on the factory harness.

These types of lights used to be more popular on most European vehicles, but are becoming common on other makes and models. Projector lights are lights that have a filament located at one focus of a reflector, and a round glass or heavy duty plastic condenser lens at the front of the lamp. These lenses in front of the light bulb distribute the light evenly across the front of the vehicle, and can give a larger range of visibility for the driver. The bulbs themselves are usually common Halogen bulbs that can easily be changed.

Select Your Part

FAQ