1990 Chevrolet Blazer Parts CAPA Halogen

FAQ

We can provide you with installation instructions if you are unsure of what tools are needed, so please contact us for more information about your specific vehicle and parts you have purchased.

Your old lights probably had moisture or condensation in them too, but the older, dulled and oxidized lens makes moisture less noticeable. Now that you have those new clear lights on your nice car, all of sudden you’re really looking at them, which is completely normal. Without going into too much detail, It's a fact that condensation happens just about anywhere. If there's a temperature difference between the inside and outside of the lens, moisture will occasionally develop, and, since your Halogen headlight bulbs put out some heat, the inside of the headlight is full of warm air while the outside is cooler. This is sort of like how the front window on your car can fog up and you have to turn on the defroster vent to clear it all away: The condensation in your headlights will usually dissipate after the headlights are turned on, as the heat of the lights evaporates the moisture. Your high beams will usually produce more heat to clear any condensation more quickly.

Your headlights will be warm to the touch from the heat generated by the bulb. The filament inside of a headlight bulb can reach temperatures of over 4000º F while the temperature of the glass surface of the bulb can exceed 150º F. This means that heat will naturally radiate to the exterior surface of your headlights. This intense heat is also what will help your headlights remain condensation and moisture free. However, to prevent burns or other injuries, be sure to let bulbs and headlight assemblies cool completely after use before handling.

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

Replacing stock Halogen headlights with HIDs would require some modifications, especially where the wiring is concerned. While the lamp can sometimes fit into the opening on the front of the vehicle, your stock lamps will use different bulbs, sockets, fuses, relays, and wiring than most HID bulbs. You may want to check with your local mechanic for advice if you have never attempted this type of conversion before.

Select Your Part

FAQ