Headlight Door LED

FAQ

HID lights can also be referred to as Xenon bulbs (though not all Xenon bulbs are HID). Some vehicle manufacturers also use Bi-Xenon headlights. Bi-Xenon means the same bulb handles the high and low beams. If you have these headlights, your projector handles both, so in short, you only need to replace one bulb to upgrade or repair the functionality of your headlight.

Halo lights are lights arranged in a ring around the headlights themselves. You've probably seen them on some cars, such as BMWs, where they are the factory option. In some cases the effect is achieved with bulbs, while on other vehicles it's done with fiber optics. Halo Lights can be a popular upgrade to make your car or truck stand out at night. Please be aware that most of theHalo lights we sell typically have to be manually wired up to your existing wiring harness. This is because your stock vehicle did not have Halos, and there is no wiring pigtail for them on the factory harness.

Replacing stock Halogen headlights with HIDs would require some modifications, especially where the wiring is concerned. While the lamp can sometimes fit into the opening on the front of the vehicle, your stock lamps will use different bulbs, sockets, fuses, relays, and wiring than most HID bulbs. You may want to check with your local mechanic for advice if you have never attempted this type of conversion before.

HID stands for "High Intensity Discharge". These bulbs use an electric arc rather than the glowing filament in a Halogen bulb. HID headlamp bulbs do not run on low-voltage DC current like a Halogen Bulb, so they require a ballast, which controls and regulates the flow of current. This ballast will require an ignitor to light the bulb. This is either integrated directly into the bulb or as a separate unit which is occasionally part of the ballast, similar to fluorescent bulbs in your home. In a vehicle, HID bulbs tend to be much more expensive to replace than a Halogen bulb.

You may well have to adjust the headlights after installation. If it's possible, when you take the old assembly out, you should match up the new adjusters with the old ones. Adjust the new light as close to that on the old units as you can. That way, any adjustments you have to make on the car once they are installed will be minimal. Our headlight assemblies have the same or improved adjusters as the stock units, and there are many videos on Youtube on how to adjust lighting. Check your owners manual too, since not all vehicles are adjusted the same way. Finally, when adjusting, make sure your car is level, with a full tank of gas.

Select Your Part

FAQ